[Polpi_91]

Originariamente inviato da d.lo

scusate ragazzi la config è quella in firma e utilizzo queste impostazioni
AI Overclock tuner: Manual
CPU Ratio Setting:7.5
FSB Frequency:400
PCI-E Frequency: 101
FSB Strap to North Bridge: 400
DRAM Frequency:1066
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: Manual

1st Information:
CAS# Latency:5
DRAM RAS# to CAS# Delay:5
DRAM RAS# Precharge:5
DRAM RAS# Activate to Precharge:15
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time: AUTO
Write Recovery Time: AUTO
Read to Precharge Time: AUTO

2nd Information :
READ to WRITE Delay (S/D): AUTO
Write to Read Delay (S): AUTO
WRITE to READ Delay (D): AUTO
READ to READ Delay (S): AUTO
READ to READ Delay (D): AUTO
WRITE to WRITE Delay (S): AUTO
WRITE to WRITE Delay (D): AUTO

3rd Information :
WRITE to PRE Delay: AUTO
READ to PRE Delay: AUTO
PRE to PRE Delay: AUTO
ALL PRE to ACT Delay: AUTO
ALL PRE to REF Delay: AUTO

DRAM Static Read Control: auto
DRAM Read Training: Auto
MEM. OC Charger: Auto
AI Clock Twister: stronger
AI Transaction Booster: Auto



CPU Voltage:1.23125
CPU GTL Voltage Reference:auto
CPU PLL Voltage:auto
FSB Termination Voltage:auto
NB Voltage:auto
DRAM Voltage:2.0
SBridge Voltage:auto
PCIE SATA Voltage:auto

Load Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew: Auto
NB Clock Skew: Auto
CPU Margin Enhancement:auto




queste sono le mie impostazioni su bios
ho un q9300 step M1
qualcuno ha qualche suggerimento per portarlo a 3.5 ghz o per farlo salire un pochetto? per ora le temperature sul core sono di 50 gradi tirati al massimo la temperatura sulla superficie rilevata da AI suite è di 22-23°c

per ora ho provato con fsb 450 e voltaggio 1.25 ma non è stabile...

Scommetti che non passi il test per questa voce?
AI Clock Twister: stronger. mettila su auto e riprova